The first thing I did was measure the height, width, and depth of my light fixture.
I measured each section off on my foam core board and drew my lines of where I would need to cut the board.
I used my razor blade to cut the foam core board.
I laid my fabric out and placed the foam core board on top so that I could cut the fabric. I added 2 inches to every side so that I’d have plenty of fabric to glue onto the board.
I hot glued all the foam core pieces together for the bathroom light fixture cover.
I hot glued the fabric onto the foam core board.
I hot glued 2 picture hanging command hooks on each side of the vanity light cover.
I pulled off the backs of the command strips and pressed them onto the wall over the top of the bathroom vanity light.